FindElectrician.co.uk

Garden Room Electrics: How to Get Power to Your Garden Office

Outdoor electrics - garden and rooftop lighting and power with RCD protection by Find Electrician
The short answer

How do you get power to a garden room?

Garden room electrics usually mean a new, dedicated circuit from your consumer unit, run out to the garden room in armoured cable, often to a small consumer unit inside the building. It’s a job for a qualified electrician, because a new circuit is notifiable building work under Part P.

Getting it right first time matters, because the cable is usually buried. This guide explains what’s involved, what to plan for, and why it’s worth running a data cable at the same time.

Garden room electrics: the circuit, the cable run and the garden room consumer unit
Power planner

What will you use in your garden room?

Tick what you plan to run. The meter gives a rough idea of the load and the kind of supply you’re likely to need.

0.7kW, roughly
LightMediumHeavy

A rough guide only. The cable size also depends on the distance from the house, so we confirm everything on a survey.

The basics

What garden room electrics usually involve

Most garden rooms are fed by a new circuit from the house, protected by an RCD. The cable is usually steel wire armoured, which is tough enough to bury or run along a wall or fence.

Inside the garden room, a small consumer unit then splits the supply into circuits for lights, sockets and any heating or air conditioning. As a result, each part is protected separately.

Part PA new circuit is notifiable building work
SWASteel wire armoured cable for the run
RCDProtection for outdoor and buried cables

Planning a garden office? We’ll design and install the power, lighting and data.

Step by step

Garden room electrics: from the house to the garden room

This is how a typical installation comes together.

1. Survey and load check

We work out what you’ll run in the garden room, especially heating, and check your consumer unit has the capacity.

2. Plan the cable route

We agree the shortest safe route, avoiding patios, trees and areas you might dig in future.

3. Size the cable

The load and the distance decide the cable size, so the voltage doesn’t drop too far at the end of the run.

4. Sort the earthing

We check whether the house earth can be extended or whether the garden room needs its own earth rod.

5. Fit the garden room consumer unit

A small board in the garden room feeds separate circuits for lights, sockets and heating.

6. Test, certify and notify

Finally, we test everything, issue your certificates and notify Building Control under Part P.

The rules

Do garden room electrics need certifying?

Yes. In England, a new circuit is notifiable under Part P of the Building Regulations. A registered electrician can self-certify the work and notify Building Control for you.

You should then receive an Electrical Installation Certificate and a Building Regulations compliance certificate. Keep both, because you’ll need them if you sell your home.

The cable route

Burying or surface-running the cable

Armoured cable is usually buried in a trench at a suitable depth, with warning tape above it, or clipped securely along a wall or fence where it won’t be damaged.

Either way, we plan the route to avoid future digging, patios and planting. Our guide to outdoor electrics also covers garden lighting and sockets.

Checklist

Garden room electrics checklist

Before you speak to an electrician, it helps to know:

  • Roughly how far the garden room is from the house
  • What you’ll use it for, such as an office, gym or studio
  • How you’ll heat or cool it through the year
  • How many sockets and lights you’ll need
  • Whether you want Wi-Fi or a wired data connection
  • Finally, where the cable could run without disturbing patios or planting

If your Wi-Fi already struggles in the house, our guide on mesh Wi-Fi vs wired access points explains how to get a strong signal to the garden.

Electrician’s tip

If you’re digging a trench for the power cable anyway, lay a spare duct alongside it. It costs very little and means you can add a data cable or more power later without digging up the garden again.

FAQ

Garden room electrics: FAQs

Do I need an electrician for garden room electrics?

Yes. A new circuit is notifiable under Part P, so it must be installed and certified by a registered electrician, or inspected by Building Control.

Can I run a garden room off an extension lead?

No. Extension leads aren’t designed for permanent outdoor use or heavy loads like heaters, and they’re a real fire and shock risk.

What cable is used for garden room electrics?

Usually steel wire armoured cable, sized for the load and the distance. It’s tough enough to bury or fix along a wall or fence.

Does a garden room need its own consumer unit?

Usually, yes. A small consumer unit in the garden room protects each circuit separately and makes it easy to switch off.

Can I get Wi-Fi in my garden office?

Yes. The most reliable way is a data cable run alongside the power to a wired access point, which gives full-speed internet.

How much do garden room electrics cost?

It depends mainly on the distance, the load and how the cable is routed. Send us a few photos and rough measurements on WhatsApp, and we’ll give you a free quote.

Planning a garden room?

We install garden room electrics, outdoor lighting and data cabling across London. Send us a few details and we’ll give you a free quote.

Talk to us

Speak to a London electrician today

Call, email or WhatsApp us for a free quote. For emergencies, we answer 24/7.

Get a free quote from a London electrician

Tell us what you need and roughly where you are, and we’ll get back to you with a free quote, usually within 12 hours. Photos of the job always help.

Rather talk it through? Call us on 07447 569653 or send us a message on WhatsApp.

We’re NAPIT-accredited (No. 65117), and every job comes with the right certificate.